Skip to main content
Skip table of contents

Bumper Errors (All Robots)

Turf Tank Robots are equipped with front and rear bumpers made of metal plates faced with soft rubber safety sensors that activate when the Robot encounters an obstacle. When the Bumper meets an obstruction, the sensor activates and the Robot immediately pauses all operations and stops the motors.

If the Bumper error is not cleared, the Robot will not operate.

Bumper errors usually clear by removing the Robot from the obstruction. Once the Bumper ceases to be in contact with the obstruction, it will typically disengage the error.

If you encounter a bumper error that won't clear easily, you must massage the entire length of the bumper to disengage the wires within the rubber casing. It may take a few minutes of massaging, but it is the only way to fix the issue.

DO NOT cut any wires leading to the Bumper. Cutting a Bumper wire will render the Robot unusable.

If you cannot clear the Bumper error after massaging the full length of the rubber casing, contact Support in your region.

NA πŸ‡ΊπŸ‡Έ πŸ‡¨πŸ‡¦ 770-818-6020

DK πŸ‡©πŸ‡° +45 89 87 04 22

UK πŸ‡¬πŸ‡§ +44 1332 323332

DE πŸ‡©πŸ‡ͺ +49 201 49869146

FR πŸ‡«πŸ‡· +33 1 87 21 45 87

NL πŸ‡³πŸ‡± +31 26 808 0240

SE πŸ‡ΈπŸ‡ͺ +46 10 888 65 46

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.