Diagnosing a Clogged Paint System
If paint does not spray out of the sprayer assembly, though you can hear the pump functioning, check the following.
Does the Suction Rod Rattle When Shaken?
The agitator in the mesh end of the Suction Rod must move freely to prevent clogs.
Shake the Suction Rod.
You should hear a rattle sound. If there is no rattle sound:
Clean the Suction Rod and its tip thoroughly.
Check for the rattle again.
If you still have no rattle, you may need a new Suction Rod (sold with tubes).
Are All the Tubes Connected Securely?
Check that all the quick connectors along the entire tubing path are securely connected.
If you have replaced any tubing, be sure the ends are cut straight. Any angle on a tube going into the quick connector can cause a lack of suction throughout the tubing.
Check the Sprayer-Nozzle Assembly for Clogs
Remove and disassemble the sprayer-nozzle assembly
Remove Quick Fan Cap.
Remove nozzle.
Remove Chamber Reducer.
Clean all parts completely with warm water.
Check nozzle carefully inside to make sure nothing is clogging it. (You can try blowing through it to make sure there is no obstruction.)
We do not recommend sticking anything inside the nozzle or using an air compressor to clear it. The nozzle can be easily damaged.
DO use warm water, soap, and a toothbrush or other small, soft-bristled brush to clear a nozzle clog.
Run water through the system with the sprayer-nozzle assembly detached.
If no water comes out, but the pump sounds like it is working, flush the paint system.