Skip to main content
Skip table of contents

Importing a Saved Location - North Base Station

When you need to migrate saved locations from one Base Station to another, follow this procedure.

Update the Firmware

Update the firmware on the Base Station to the current version if possible.

Before updating the firmware, confirm that the customer has not created any Saved Locations on the older firmware that are within 25 yards of another Saved Location.

We do not recommend updating the firmware if any of the customer's Saved Locations are within this range of each other, as the base station might have difficult establishing its position using Auto-Select on the newer firmware versions.

Install the Base Station on the Tripod

  1. Center the prism pole on a designated fixed position that you have created with a ground marker.

  2. Ensure that the bubble on the prism pole is level throughout the following process.

Pair the Base Station with the Tablet via Bluetooth

  1. Pull down the notifications menu from the top of the screen.

  2. Hold the Bluetooth Symbol until a second screen appears with available Bluetooth devices displayed.

  3. Select the RNBT device to begin the pairing process.

  4. Follow the on-screen directions and the tablet will indicate that it has successfully paired to the RNBT XXXX (Base Station)

  5. On the Base Station, navigate through the Set Location menu to Saved Location.

  6. Set the base station on the number of the Saved Location you will be creating.

  7. Go to the IM SERVICE app on the Tablet.

  8. Press the “Connect” command in the top right corner.

  9. You will be prompted to select an (already-paired) Bluetooth device.

  10. Click on the displayed RNBT XXXX that is displayed

  11. Take note of the connection status at the top of the screen on the left side. (Connecting / Connected or Disconnected)

  12. Once connected, select the corresponding location number to the one displayed on the base station and back out the language and type in the name desired for this saved location. Note: this new name you create will NEVER appear on the tablet but will be displayed on the base station going forward.

  13. After typing the name for this Saved Location, tap the “Connect” button in the middle of the screen on the right side.

  14. Wait approximately 5 – 10 seconds and the base station will begin to ”chirp” as it records in the base station position in the sleeve in the ground. Note: you may notice that the Tablet now shows disconnected. This is intended. The tablet no longer needs to be connected to complete the process.

  15. When the chirping stops, the logging of the location data is completed and if all steps are performed correctly, you will get a notice on the screen for a few seconds: WKP Results OK

  16. The base station will then automatically return to the main screen for BASE UHF

  17. To further ensure that all was done correctly, check to make sure the TX is displayed in the lower right of the screen. That TX means the base station is transmitting UHF Signal.

  18. You are now ready to elevate the base station the operational height of nine to twelve feet.

Bluetooth pairing only needs to be done once. If you have ever done it before with your current Tablet and Base Station, they should recognize each other.

The Base Station is usually identified as RNBT XXXX.

The Base Station will only communicate with the tablet to pair and connect with it when it is one of two conditions: Saved Location mode and Settings by App mode. Do not attempt to pair or set a new location unless it is in Saved Location / Settings by App mode.

It is not unusual for the Bluetooth connection to fail once or twice before connecting to the tablet. Simply repeat the steps described above when this occurs.

Should you have any unexpected results at any of these steps, revert back and start again from the beginning.

Older base stations use the word Location instead of Position

Click through for Base Station menus: https://xd.adobe.com/view/08a2226d-7c97-4571-9830-291ddff0d6f6-5df1/?fullscreen

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.