Skip to main content
Skip table of contents

Replacing Sprayer Unit (aka Solenoid)

For general Sprayer Unit and Solenoid assembly, see: Prepare the Paint System

The Sprayer Units on the Turf Tank One, Turf Tank Two, and Turf Tank Lite differ slightly, but the primary components are the same. Replacing the Sprayer Unit (or Solenoid) is the same process for every model of Robot.

Tools Needed:

  • 8 mm hexagonal socket

  • Wrench extension

  • Socket wrench

  • Needle nose pliers

The valve that makes the Sprayer Unit function is referred to as the Solenoid. If it is not closing sufficiently, due to clogging or paint particulates sticking to it, you need to replace the unit.

Remove Old Valve Solenoid

  1. Clean the Sprayer Unit area thoroughly.

  2. Remove the Sprayer Assembly (Quick Fan Cap, nozzle, Chamber Reducer).

  3. Flush the Paint System by running water through until the water comes out clean.

  4. Unscrew (counter-clockwise) the electrical connector plug on the top of the Solenoid.

  5. Unplug the clear paint tube from the top of Solenoid.

    1. The tube is secured with a compression connector, which must be pushed inward to release.

    2. Once released, pull the tube out gently.

  6. Locate the two bolts that connect the Solenoid to the frame (one on either side of the Sprayer Unit).

  7. Use the 8 mm socket wrench, with the extension attached, to undo the nuts on those Solenoid bolts.

  8. Remove the nuts and washers.

  9. Pull the Solenoid unit toward you to remove it from the Robot frame.

Install New Solenoid

  1. Place new Solenoid, nozzle end down, so the two bolts line up with the holes.

  2. Place the washers back onto the bolts.

  3. Place the nuts back onto screws and tighten with the 8 mm socket wrench.

  4. Gently push tubing back into the compression fitting on the top of the Solenoid.

  5. Line up the electrical connector to the port on top of the Solenoid.

  6. Screw the electrical connector into the port clockwise.

  7. Test the Solenoid by inserting the Robot battery and reattaching the Sprayer Assembly.

    1. The Solenoid should light up.

    2. Run water through the system to ensure the Solenoid is spraying properly.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.