Skip to main content
Skip table of contents

Tighten the Wheels and Motors

If you notice your Robot wobbling a bit as it paints or if the wheels seem loose, you may want to tighten down the wheels and the motors.

🛞 Access the Wheels and Axels

  1. Remove Spray Guard.

  2. Pop off the center wheel caps with a flathead screwdriver.

  3. Use 17 mm hex socket wrench to remove center wheel bolt and washers.

  4. Slide wheel off axle to remove.

  5. Using a 4 mm Allen wrench, tighten the four bolts holding the motor to the chassis.

  6. Replace the wheel bolt and washers as they were when you removed them.

  7. Tighten the 17 mm hex bolt as far as it can go.

It is best to use a ratchet socket wrench to tighten the bolt. Do not use a drill with a socket wrench as it can overtighten the bolt, making it difficult to remove later.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.