Skip to main content
Skip table of contents

Replacing the Control Unit (Turf Tank One+)

Tools Needed

  • Long needle nose pliers 

  • 4 mm hex/Allen wrench 

Method 

  1. Remove battery from Robot. 

  2. Open both Robot shields.

  3. Use long needle nose pliers to unscrew and remove all cables and the WiFi antenna from the left side of the controller. 

    Four cables and a WiFi antenna attached to the controller of a Turf Tank One Robot.

    Cables and WiFi antenna connected to controller.

  4. Gently pry up and remove both screw covers from the controller. 

    Turf Tank One Robot controller with a yellow arrow showing pointing out the recessed screw covers that need to be lifted to remove the controller.

    Remove the screw covers.

  5. Using a 4 mm Allen wrench, remove the four recessed screws from the controller. Do not remove the visible screws.

    Only remove the recessed screws.

  6. Attach the new controller by following these steps in reverse.

  7. Make sure the cables are all plugged back into the correct connector.

  8. Tighten the screw collars well, but be careful not to strip the grip texture.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.