Skip to main content
Skip table of contents

Robot Operation

Troubleshooting Basic Robot Issues

Issue

Cause

Action

Bumper Engaged error in App; obstacle has been cleared/there is no obstacle.

The Bumper sensor is stuck.

Gently massage along the length of the rubber bumper to reset the connection inside it.

The Bumper sensor is faulty.

Replace the bumper.

Paint spray pressure seems low.

Paint system is clogged.

Clean the paint system.

Paint tubing is bent, suction rod has a crack, tubing is not fully seated in compression fittings.

Clean and then check the paint system for holes, cracks, secure fittings.

Paint is too thick.

Dilute paint more.

Paint line is not wide enough, despite settings.

The spray angle of the nozzle is too narrow.

Change to a nozzle with a wider spray angle.

Paint system is clogged.

Clean paint system.

Paint sprays only out of one side of the Nozzle.

Paint spray does not disperse evenly out of the Nozzle.

Nozzle is clogged.

Clean or replace the nozzle.

Paint line extends beyond where it is supposed to stop.

The solenoid which closes the paint flow valve is faulty.

Solenoid needs to be replaced. Contact your Turf Tank Representative or call Support.

Operating distance between Robot and Base Station is considerably reduced.

Antenna on Robot is missing or broken.

Antenna on Base is missing or broken.

Replace antenna.

App will not connect to the Robot.

Tablet is not connected to the Robot’s WiFi.

Connect tablet to Robot WiFi using the tablet’s WiFi settings menu.

The Robot will not drive.

Emergency Stop Button is pressed.

Release the Emergency Stop Button.

Battery connection has come loose.

Is the battery compartment latch locked?

For Robot operation issues not listed here, contact your Turf Tank Representative or “SUPPORT.”

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.