Skip to main content
Skip table of contents

Routine Robot Operation

Operating the Robot after the First Time

Once you have set the Base Station’s position(s) and have at least one field plan ready to paint, follow these steps:

Power

  1. Ensure all components' batteries are charged.

  2. Insert the Robot Battery into the Battery Box in the Battery/Paint Compartment.

  3. Make sure the Battery Latch is pointed down, securing the Battery in place.

  4. Power on the Robot completely.

  5. Power on the Tablet.

  6. Set up the Tripod and Prism Pole with the Base Station attached.

  7. Set the Prism Pole into the installed Ground Spike.

  8. Power on the Base Station.

When powered on in a position you have already set, the Base Station automatically finds that position when it is powered on. There is no need to press any buttons. Simply turn on and you’re ready to go!

Connect

  1. Connect the Tablet to the Robot’s WiFi network.

  2. Open the Turf Tank Control App.

  3. Ensure the Robot is connected in the App.

  4. Check for satellite signal strength on the Base Station and in the App.

Paint

  1. Place a jug of water or paint into the Robot’s Battery/Paint compartment.

  2. Seat the rubber stopper that holds the Suction Rod assembly into the mouth of the jug.

  3. Construct or check the Sprayer Assembly, making sure to install the Quick Fan Cap, Gasket, Nozzle, and Chamber Reducer properly.

  4. Use the manual Sprayer On and Off commands in the App to prime the Pump and test the Spray System.

  5. Manually drive the Robot onto the field.

  6. Select the field plan you wish to paint in the App.

  7. Paint!

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.