Skip to main content
Skip table of contents

Safe Operating Instructions - Turf Tank One+

The Turf Tank Robot should only be used for its intended purpose:

  • Painting lines and other markings on sports fields, pavement, dirt/fine gravel, grass, other hard surfaces.

DO NOT leave the Robot unattended during operation.

  • The operator shall be able to see the Robot while operating.

  • The Robot cannot sense its surroundings nor detect buildings, people, or other obstructions.

Ensure no persons or obstacles are in the operation area before using the Robot.

  • The operator should check that no people, animals, or obstacles are within the Robot’s working area before beginning autonomous operation.

  • When operating autonomously in public areas (e.g. near schools, playgrounds, etc.), special care should be taken to prevent unauthorized persons from approaching the Robot.

ALWAYS observe work-related safety regulations (EU-OSHA and OSHA).

DO NOT attach anything to or place anything onto the Robot during operation.

Avoid driving the Robot near obstacles or on slippery surfaces.

  • The Robot should be operated only on flat areas with no steep slopes or large holes.

  • The operating area should be free of snow, ice, mud, and fallen leaves, branches, or other obstacles that could interfere with safe operation.

  • Failure to follow this instruction could cause technical error or personal injury.

DO NOT operate the Robot in unsafe conditions.

  • “Unsafe Conditions” include, but are not limited to:

    • extreme weather conditions.

    • high winds.

    • tornados.

    • electrical storms.

    • dense fog or limited visibility.

Heed all Safety Warnings and Alerts in the App from the Robot.

  • Such warnings and alerts may indicate unsafe operating conditions.

  • Read the Safety section of this guide in its entirety.

  • Heed Safety Alerts and respond appropriately.

DO NOT wear gloves when operating the tablet.

  • Gloves can prevent the tablet from sensing operator input.

  • This is especially important if you need to stop the Robot from within the App due to an emergency.

Use only the supplied charger to charge all supplied batteries.

  • DO NOT connect a charger if there is any visible damage to the charging cables or connectors.

  • Plug the battery charger into a surge protector to protect it from power surges and voltage spikes.

  • Follow ALL battery-handling and battery-charger instructions in this Product Manual.

Power down Robot completely and REMOVE THE BATTERY before performing any maintenance or installation.

  • You may swap out the Robot’s battery without turning the power off.

  • For all other maintenance or part installation, power down the Robot and remove the battery before performing any maintenance or installing any part or accessory.

DO NOT disassemble or open the Robot for service.

  • The Robot may only be disassembled, opened, or serviced by trained personnel with the express consent and guidance of a Turf Tank Technical Support Analyst, Field Operations Engineer, or other representative.

  • In case of component failure, do not attempt to replace the part yourself unless expressly authorized and guided to do so by Turf Tank personnel.

DO NOT modify the Robot.

  • Modifications to the Robot could interfere with its operation and result in serious injury and/or damage.

  • Any modifications or unauthorized service will void the Robot’s Limited Warranty.

Use relevant safety equipment when cleaning or performing maintenance on the Robot.

  • We recommend wearing gloves while performing maintenance and cleaning of the spray module.

  • Regular cleaning and maintenance of the paint system, the body, and the wheels of the Robot should be performed according to this Product Manual and App instruction.

  • All other parts of the Robot, including all internal parts of the controller, GPS receiver, battery, fuse box, etc., should be serviced only by authorized service personnel.

  • DO NOT use high-pressured cleaning equipment on the outside or the inside of the Robot.

Heed paint information, warnings, and safety instructions.

  • Use only water-based paints approved for Robot usage.

  • Comply with all relevant health and safety instructions for the paint used, including proper use of protective equipment.

  • DO NOT use flammable paints or paints containing organic/chemical solvents to avoid damage to the paint tubes and pump and potential harm to operators.

Resetting the Robot after an Emergency Stop.

  • To disengage the Emergency Stop button, turn the Emergency Stop button clockwise.

  • When the Robot stops due to a safety bumper activation, the Error alert will go away as soon as the obstacle is gone and the Bumper clears.

  • If the Robot still will not drive or the Error will not go away, gently massage along the length of the rubber Bumper to reset the connection inside it.

  • After resetting, manually drive the Robot to an appropriate starting position clear of the obstruction before resuming autonomous operation.

Always Follow These Guidelines When Transporting the Robot:

Because the Robot and the Base Station use Lithium-Ion batteries, a Dangerous Goods Note must be completed when hiring a freight company to transport the Robot.

Turf Tank cannot be held liable for any failure to abide by international transportation laws.

  • Take care to use proper form when lifting the Robot.

  • Be sure to hold the Robot securely.

  • Two people should handle the Robot for lifting and transporting to help prevent physical injury or damage to the unit.

Two people are required to lift the Turf Tank Robot safely.

  • Lift the the Robot using the handholds built into its front and back bumpers.

The Robot is equipped with a large red Emergency Stop Button.

  • If the Button is pressed while the Robot is moving, it will immediately stop moving and spraying, and it will raise its discs.

  • The Button lights up when it is engaged.

  • The Robot cannot operate until the Button is released. Release the Button by turning it clockwise.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.