Safety Features
The Turf Tank One+ (the “Robot”) has been designed to operate safely and easily. Some safety features are always active and others only activate during autonomous operation.
Main Indicator Light

The light on the front of the Turf Tank One+ indicates its state and mode of operation. Please refer to the section “SAFETY WARNINGS AND MESSAGES” for a detailed description of the blink patterns' meanings.
Ignition Switch

Directly under the Main Indicator Light on the front of the Robot is the Ignition Switch. A quarter turn clockwise (to the “ON” position) powers on the Robot. A quarter turn counterclockwise (to the “OFF” position) turns off the power to the robot.
Power Breaker Switch

The Power Breaker Switch (or just “Breaker Switch” or “Breaker”) is located under the right-side cover (when viewed from the front) on the front wall of the Battery/Paint Compartment. Flipping this switch to the ON position (indicated by a l) will power the Robot’s control unit. The OFF position (indicated by a O) cuts power to all circuits.
Turn OFF the Breaker Switch when a painting session is finished to avoid draining the battery. Full discharge can permanently damage the battery.
Turn Breaker Switch OFF to service the Robot or when cleaning the Robot with water.
To cut power completely to all parts of the Robot, BOTH the Breaker Switch and the Ignition Switch MUST be turned OFF.
Turn off the Ignition Switch first. When the lights on the Control Unit all go out (after 10-20 seconds), turn off the Breaker Switch.
Emergency Stop Button

The Emergency Stop Button, located on the front of the Turf Tank One+, stops all Robot operation when pressed. When active, the Emergency Stop Button lights up.
Normal operation cannot resume until the Emergency Stop Button is released. Release the Emergency Stop Button by turning it counter clockwise.

Front and Rear Bumpers
Front Bumper:

The Turf Tank One+ is equipped with front and rear bumpers made of metal plates faced with soft rubber safety sensors that activate when the Robot encounters an obstacle. When the Bumper sensor activates, the Robot immediately pauses all operations and stops the motors.
Rear Bumper:

Each bumper plate on the Turf Tank One+ features two lifting handles. To prevent injury or damage to the Robot, the Robot should be lifted by two people.