Skip to main content
Skip table of contents

Clean Robot Body

DO NOT use a pressure washer to clean the Robot.

DO NOT use paint thinners or chemical solvents to clean the Robot.

Clean the paint, dirt, turf, and mud the Robot picks up on a normal day from the shell, chassis, wheels, and spray discs after every use to keep it looking sharp and performing at its peak.

Wet paint is far easier to clean than dry. Cleaning the Robot is simple and easier to do immediately after painting.

Shell

The Robot’s plastic shell is the easiest part of the Robot to clean.

Remove all but the most stubborn dried paint with a natural sponge (or a gentle scrubber sponge--any sponge labeled safe for china or quality cookware is safe for the Robot) and a gentle cleaner, such as dishwashing liquid, or mild all-purpose cleaners.

If you have a custom painted or wrapped shell, clean only with a soft cloth or sponge and gentle cleaners. Test your cleaning method on a less visible spot to ensure your custom finish is not damaged.

Do not wipe wet paint from the shell with a dry rag or sponge, as it leaves a thin film of paint that is harder to clean once it dries.

All of these instructions also apply to cleaning the plastic pump cover.

Chassis

The steel of the Robot’s chassis is best cleaned with a sponge for wet or semi-dry paint, or a pliable scrub brush for more hardened splatters. For tougher paint deposits, dishwashing soap or mild all-purpose cleaner can help.

Do not wipe wet paint from the chassis with a dry rag or sponge, as it leaves a thin film of paint that is harder to clean once it dries.

Wheels

Remove any large chunks of turf or mud from wheels as soon as possible before they dry. You can rinse the wheels clean with a garden hose.

Spray Discs

The discs that guide the paint spray quickly become covered with paint. Wipe the discs with a damp cloth or sponge to remove the worst of the paint. As always, it is easier to wipe the discs when the paint is wet.

Should paint build up, the Spray Discs can be removed from their arms by removing the nut and washers on the outside (away from the sprayer head) faces of the discs. Once the discs are removed, you can wash them in a sink like cookware or any other stainless steel.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.