Skip to main content
Skip table of contents

Install the Ground Spike

The constant Base Station position is marked by the Ground Spike, a rigid piece of plastic inserted into the ground. The Ground Spike provides a reference spot for the Prism Pole placement to keep the Base Station position consistent and your fields accurate every time.

Install the Ground Spike:

  1. Position the sharp end at the marking point on the ground.

  2. Hit the flat top of the Ground Spike with a rubber mallet.

  3. Drive the Ground Spike into the dirt until the flat top is even with the ground.

The ground shouldn’t be too hard or too soft when you drive the Ground Spike to avoid breaking the Spike or losing your position.


JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.