Adjust Spray Width
The Sprayer must be adjusted at the beginning of a new program to obtain the best result. For Turf Tank it is important to paint clear lines and to do this, it is important that the spray cone shown in picture XX. hits the bottom of the spray discs.
Setting the Spray Width consists of the follow steps:

Setting the Spray Disc distance
Setting the Sprayer height
Setting the Spray Disc distance
Use the knob furthest from the Sprayer to adjust the distance of the Spray Discs To increase the distance turn the Spray Disc Knob counterclockwise

To decrease the distance turn the Spray Disc Knob clockwise.

Use the integrated ruler on the Sprayer cover to set the correct width of the painted line.
Setting the Sprayer Height
Coarse Adjustment
The Sprayer coarse adjustment is done by pulling out the pin on the Sprayer and moving the whole assembly up or down. The height of the Sprayer can be set every 5 mm or 1/5 inch. To set the Sprayer height, release the pin and let it fall into the closest hole. There is also a ruler with letters on the side of the height adjustment block. These letters allow for the Sprayer to be quickly set to the same height after nozzle replacement.

Fine Adjustment
To fine tune the spray cone so that it hits the bottom of the discs, use the knob closest to the Sprayer. Turn the knob clockwise to raise the Sprayer. This will widen the spray cone. Turn the knob counterclockwise to lower the Sprayer, which will decrease the width of the cone.

Please note
A nozzles package is delivered with the robot.
The Sprayer must be adjusted at the beginning of a new program to obtain the best result. For Turf Tank it is important to paint clear lines and to do this, it is important that the spray cone shown in picture XX. hits the bottom of the spray discs . In order to do this, it is possible to adjust the height of the sprayer and the distance of the discs. Changing the nozzle can also improve the quality of the lines and use less paint.

Using the discs helps to ensure line width accuracy and make sure to comply with the sports requirements. With the handle on top of the sprayer module, it´s possible to easily adjust the distance between the discs. Turning the handle to the the left brings the discs closer while the opposite movement moves them away.

Below the disc there is a bar that helps their up/down movement. On this bar there are numbers that show the distance between the discs. Move the discs at the distance required from the kind of sport field.

The spray has been designed to easily setting the height of the sprayer. With a specific handle and with a precise numbering system it is now possible to settle different settings with millimetric precision. The following steps are showing how to use the system;
Loose the handle and move it up or down to position the sprayer in the position needed (img.XX);

Check the numbering system placed on the right side of the sprayer to decide the right height of it. Be sure that the number is positioned inside the hole
(img.X2)

If it is needed it´s possible to detach the sprayer. It gives the possibility to try the sprayer before using it and to finish the line when the robot can´t reach the goal post
(img.X3)
