Skip to main content
Skip table of contents

Load Paint

Notes on Paint Used in Turf Tank Robots

Turf Tank Robots use mixed paint concentrate or ready-to-spray (RTS) formulas supplied by Turf Tank or select paint manufacturers. Paint must be approved for use in Turf Tank Robots.

Both concentrated paint and RTS must be thoroughly mixed to reduce sediment that can cause clogs in the paint system. Mixing is best accomplished with a mixing bit attached to a power drill.

The Turf Tank Two paint compartment is open and accessible so you can easily check paint levels and swap jugs.

  1. Move the suction rod and paint tube outside the paint compartment.

    1. Do not disconnect any part of the suction rod or paint tube.

  2. Insert the jug into the paint compartment with the mouth of the jug toward the rear of the Robot.

    1. The compartment is angled to ensure the suction rod can reach all the paint.

GettingStarted_LoadPaint_2-01-20240223-183014.jpg
  1. Remove the cap from the paint jug.

GettingStarted_LoadPaint_3-01-20240223-183020.jpg
  1. Store the paint jug cap in the tray on the pump cover.

GettingStarted_LoadPaint_4-01-20240223-183030.jpg

  1. Insert the suction rod into the jug.

  2. Push down to firmly secure the rubber stopper into the mouth of the jug.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.