Skip to main content
Skip table of contents

Prepare the Paint System

The Paint System

These are the elements of the Paint System, from the Suction Rod that goes into the paint jug to the Nozzle that sprays the paint:

Suction rod: a rigid, hollow rod of plastic with a non-removable mesh housing on the bottom.

Rubber stopper: a soft, graduated rubber stopper with a hole that allows the suction rod to pass through; it seals the paint jug and holds the suction rod in place in the paint jug.

Compression fittings: all of the tubes and rods in the paint system attach with compression fittings for secure connections.

Flexible plastic hoses/tubes: flexible tubes that move the paint from the suction rod to the pump, then from the pump to the sprayer head assembly.

IndicatingTubes-01-20240226-181335.png

Tubing

Inline mesh filter in filter housing: fine metal mesh sleeve inside rigid, screw-top housing connected with compression fittings to the hoses. The inline mesh filter provides another level of paint straining to prevent any large particles from reaching the pump.

InlineMesh-01-20240226-175836.png

Inline Mesh Filter and Filter Housing

Pump: Low-pressure pump to draw paint from the jug and deliver it to the sprayer head.

OpenPumpCover-01-20240226-181404.png

Pump

Sprayer Head Assembly: consists of solenoid to power the opening and closing of the sprayer, a chamber reducer to increase the pressure in the sprayer head, a gasket to prevent paint dripping, and a nozzle tip to dispense paint.

Prepare the Paint System

On first use, assemble the components of the paint system and prime the pump.

Insert the Inline Mesh Filter

  1. Unscrew the lid from the filter housing.

  1. Insert the inline mesh filter.

  1. Replace the lid on the filter housing.

Check All Compression Fittings

If a tube needs to be removed: (1) press in the collar and, at the same time, (2) pull out the tube. Reinsert the tube by pushing it back into the compressed collar. Be sure to seat the tube all the way into the opening before letting the collar clamp shut.

Complete the Sprayer Assembly

The sprayer assembly already contains the solenoid and valve to control paint flow. Customizable nozzles are added to the tip to alter the pattern and size of the lines the Robot paints.

  1. Remove the quick fan cap.

  1. Insert the nozzle, rubber gasket, and chamber reducer

  1. Mount the quick fan cap onto the sprayer by seating it into the sprayer body and twisting a quarter turn counterclockwise until it locks.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.