Skip to main content
Skip table of contents

Routine Robot Operation

Operating the Robot after the First Time

Once you have set the Base Station’s position(s) and have at least one field plan ready to paint, follow these steps:

Power

  1. Ensure all components' batteries are charged.

  2. Insert the Robot Battery into the battery compartment.

  3. Power on the Robot completely.

  4. Power on the Tablet.

  5. Set up the tripod and Prism Pole with the Base Station attached.

  6. Set the Prism Pole into the installed Ground Spike.

  7. Power on the Base Station.

Connect

  1. Connect the Tablet to the Robot’s WiFi network.

  2. Open the Turf Tank Control app.

  3. Ensure the Robot is connected in the app.

  4. Check for satellite signal strength on the Base Station and in the app.

Paint

  1. Place a jug of water or paint into the Robot’s paint compartment.

  2. Seat the rubber stopper that holds the Suction Rod assembly into the mouth of the jug.

  3. Construct or check the sprayer assembly. Make sure to install the chamber reducer, gasket, nozzle, and quick fan cap properly.

  4. Use the manual Sprayer On and Off commands in the Turf Tank Control app or on the Robot’s control panel to prime the pump and test the spray system.

  5. Manually drive the Robot onto the field.

  6. Select the field plan you wish to paint in the app.

  7. Paint!

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.