Skip to main content
Skip table of contents

Where is the "Center of the Rover" on the Turf Tank Two?

How Do I Find the Rover?

Some Turf Tank Control App field plans require you to place a point using the “Center of the Rover” as a reference (some American Football gooseneck-goal plans, for example. See Tip below!).

If you have seen a Turf Tank One, the “head” of the Robot is the Rover, also known as the DNSS antenna.

On the Turf Tank Two, the Rover has gone undercover, literally! Finding the center of a Rover you cannot see is a bit tricky.

Locating the Center of the Rover for Point Placement

The Center of the Rover across the width of the Robot can be found by locating the third screw from the right on the top of the Robot’s front safety bumper. This screw sits between the two handholds on the front bumper.

Draw an imaginary line (or use a string) from that screw to the top of the shield.

Stop that line at a point even with the center of the spray discs (where the bolts hold the disc to the arm). Draw an imaginary line even with that point to intersect with the line coming up the front of the Robot.

This intersection point is the Center of the Rover. If you use plans that require this point often, you might wish to mark this point with a marker or sticker.

Red lines mark the imaginary lines that intersect on top of the Robot at the Center of the Rover point.

🚀 TIP

Our Employee Success Trainer has a great trick for finding the exact spot of a gooseneck goalpost for the Robot to place a point, whether you are doing it under the sprayer or the center of the Rover:

  1. Take a length of fishing line long enough to double the distance from the goalpost to the field surface.

  2. Securely tie the fishing line around a metal washer, flat-disc sinker weight, or similar metal object that can be tied onto fishing line.

  3. Toss the weighted end of the line over the goalpost crossbar, holding onto the unweighted end.

  4. Gather the weight and align it to the spot you need to mark, keeping the fishing line taut.

  5. You can either spray a dot over the weight or drive the Robot so the weight is directly under the desired point on the Robot (sprayer, center of Rover, etc.).

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.