Skip to main content
Skip table of contents

Prism Pole and Tripod Set Up

1. Insert the Prism Pole into the ring at the center (the “spider”) of the Tripod.

2. Tighten the knob to secure the Prism Pole.

3. When you are ready to set up for painting, insert the Prism Pole into the Ground Spike.

4. Using the telescoping leg locks, adjust the angle of the Tripod’s legs to approximately 30 degrees.

If the angle of the legs is too small (acute), the Tripod and Prism Pole will be less stable.

5. Drive the foot of each leg into the ground by pressing the button (1) while simultaneously pushing down on the placement collar (2) with your foot.

6. Press down two buttons at a time to adjust the angle of the Prism Pole, alternating moving the legs until the bubble level on the spider is centered.


JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.